XRAYドライバーMike Gosvig選手、XB4'15の使用オプションパーツを公開

XRAYドライバーMike Gosvig選手が、XB4'15の使用オプションパーツを公開しました。


* 366220: Independent Servo Mount - Set for better flex in the chassis, giving more flex and more steering

* 368286: Rear Spring-Set - 3 Dots (2) and 368186: Front Spring Set - 4 Dots (2) are used every time on carpet tracks. These springs are my best option for good landing, steering, and corner speed.

* 362573: Alu Steering Plate 4-Hole gives me more precise steering, and also more Ackermann adjustment. This part is very good on high-traction tracks, too.

* 361103 Alu Chassis - Swiss 7075 T6 (3mm) is used every time when I race on carpet. This chassis allows me to take the upper decks off the car, and gives more traction and steering. Sometimes I use the 361168 Graphite Chassis Brace Upper Deck - Short Pack (2) to stiffen the chassis when I need to on super-high-traction tracks.

* 365351: Alu Wheel Hub - Offset -0.75mm (2) are used sometimes to give the car a bit more steering into corners. This part is also helpful in front to remove some steering and make the car easier to drive.

* 363511: Lexan Rear Wing 1.5mm (2) is 0.5mm thicker than the original rear wing. It lasts longer and puts more weigth in the rear of the car when the wind hits it for more steering and stability.

* 365471-o: Alu Drive Shaft Safety Collar - Orange (3) strengthens the drivetrain when I need to push the car to the limit, and it also looks very nice.

* 293561-O is stronger for holding the rear wing, and it also looks very nice.

* 365000: Ball Adjustable Differential - Set - HUDY Spring Steel(tm) is sometimes used at the front of the car at high-traction tracks to take away some of the 'edgy' steering out of the car.

https://www.teamxray.com/